Cart $0.00
0
0
Subtotal: $0.00
No products in the cart.

Volvo All Engines (2010 Emissions) Fault Code: SPN 5443 FMI 2 PID: PPID 329 Aftertreatment 1 Hydrocarbon Dosing System

The Aftertreatment Hydrocarbon Dosing Module contains three non serviceable valves, the Aftertreatment Fuel Shutoff Valve, Aftertreatment Purge Air Valve and Aftertreatment Hydrocarbon Dosing Valve, and a serviceable Aftertreatment Fuel Pressure Sensor.
During DPF regeneration the Engine Control Module (ECM) sends a voltage signal to activate the Aftertreatment Fuel Shutoff Valve to the open position. This allows fuel to flow into the Aftertreament Hydrocarbon Dosing Module. The Aftertreatment Fuel Pressure Sensor monitors the fuel pressure value and sends a reference signal to the ECM. The ECM then sends a PWM signal to the Aftertreatment Hydrocarbon Dosing Valve that regulates the amount of fuel delivered to the Aftertreatment Hydrocarbon Doser through the air/fuel line.
During Air Purge operation the Engine Control Module (ECM) sends a voltage signal to activate the Aftertreatment Purge Air Valve open. This allows air pressure to flow into the Aftertreament Hydrocarbon Dosing Module. The ECM then sends a PWM signal to the Aftertreatment Hydrocarbon Dosing Valve that allows purge air pressure to be monitored by a signal from the Aftertreatment Fuel Pressure Sensor to the ECM.

Conditions for diagnostic trouble code (DTC):
1) Aftertreatment Fuel Pressure, not within expected range
2) Fuel pressure fault

Observable symptoms
1) Regeneration not possible

Probable cause
1) Fuel pressure
2) Fuel line(s)
3) Aftertreatment Hydrocarbon Dosing Module

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 5443 FMI 2 PID: PPID 329 Aftertreatment 1 Hydrocarbon Dosing System”

Your email address will not be published. Required fields are marked *