The pedal message is used to calculate fuel injection.
The J1587 and J1939 serial data lines are used as the standard communication link for on-board vehicle instrumentation, off-board service diagnostics and fleet management.
The (VECU) Vehicle Electronic Control Unit is linked to the Engine Control Module (ECM) via these data lines.
Conditions for diagnostic trouble code (DTC):
1) Open circuit
2) The voltage at pin A17.PB:8 is less than 0.7?V
Observable symptoms
1) The engine does not respond when accelerator pedal is pressed.
2) Missing kick-down effect
Probable cause
1) Connector
2) Supply wire, Open circuit
3) Signal wire, Open circuit
4) Signal wire, Short circuit to ground
5) Accelerator pedal, Sensor
-
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )
Trucks software $80.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5 -
DAF Davie Runtime v5.6.1 Davie XDc ll [02.2019] + Expire Fix 302.00 Unlock ( Windows 7 )
DAF $70.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2729 Pressure Control Solenoid 1 (PCS1) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2670 Actuator Supply Voltage 2 (HSD2) – Low
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P097B Shift Solenoid 2 (SS2) Control Circuit – Open
1000 & 2000 Gen 5Rated 0 out of 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low
1000 & 2000 Gen 5Rated 0 out of 5
-
Eaton Gen 1 (AutoShift) Fault Code: 42 PID: SID 61 FMI: 7 Splitter Failed To Engage
DTC TRUCKSRated 0 out of 5 -
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 91 FMI 13 (CPC) Data Out of Calibration
DD16 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 986 FMI 13 (CPC) CPC has Received A J1939 CM1 Message
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 110 FMI 16 (CPC) Coolant Temperature High
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Volvo All Engines (2013 Emissions) Fault Code: P053E00 PID: EMS Crankcase Pressure Too High
All Engines (2013 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 84 FMI 13 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #1, #2 or #3 is Missing
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 1231 FMI 9 (MCM) Aftertreatment Control Module Message Not Received or Has Stopped Arriving
DD13 GHG14 (2014-16)Rated 0 out of 5 -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 14 PID: 122 SPN: FMI: 5 Med/High Retarder current low
3406E (Prefix 5DS or 1LW)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 558 FMI 6 (CPC) Open Circuit; Idle Validation Switch 2 Circuit Failed High
DD15 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 710 FMI 4 (CPC) Digital Output 4 06 Circuit Failed Low
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 110 FMI 14 (MCM) Coolant Temperature/Engine Oil Temperature Plausibility Fault
DD16 EPA07 (2007-09)Rated 0 out of 5 -
Allison 3000 & 4000 Gen 4 Fault Code: P2637 Torque Management Feedback Signal – SEM
3000 & 4000 Gen 4Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 9 (MCM) Message Not Received or has Stopped Arriving
DD13 EPA10 (2010-13)Rated 0 out of 5