CAT 3406E (Prefix 1MM or 2WS) Fault Code: 25 PID: SPN: 102 FMI: 4 Boost Pressure voltage low
The Engine Control Module (ECM) detects the following conditions:
•The signal voltage from the boost pressure sensor is greater than 4.95 VDC for more than two seconds.
•The ECM has been powered for at least two seconds.
•The engine is not running or the rack position is less than 50 percent with the engine retarder off.
Probable Causes:
1) ECM Connection/Harness
2) Crankcase breather plugged
3) Pressure sensor
4) Pressure sensor harness
5) ECM Failure
-
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5 -
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00Rated 0 out of 5
Related products
-
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
CAT 3126B Fault Code: 70-05 PID: Flash Code 49 SPN: 729 FMI: 5 Inlet Air Heater Open Circuit
3126BRated 0 out of 5 -
CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT $45.00Rated 0 out of 5 -
CAT 3126B Fault Code: 231-11 PID: Flash Code 58 SPN: 639 FMI: 12 J1939 Data Link Fault
3126BRated 0 out of 5
-
SERVICE MANUAL DETROIT DIESE LDDEC VI – CPC Vehicle Interface Harness Schematic
DETROIT $15.00Rated 0 out of 5