CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 84 SPN: FMI: 14 Quick Stop Occurrence
The Engine Control Module (ECM) detects the following conditions:
•The vehicle speed slows at a rate that exceeds the “Quick Stop Rate” that is programmed.
•The service brake is applied.
Probable Causes:
•The parameter for the “Quick Stop Rate” may be set too low.
Note: This setting can be affected by the load on the vehicle. If the vehicle is operated without a trailer or with no load, the vehicle will stop faster than the same vehicle with a heavy load.
-
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5 -
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00Rated 0 out of 5 -
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5 -
DOWNLOAD Paccar ESA Electronic Service Analyst 5.5.0 Diagnostic Software 2023
PACCAR $96.00Rated 0 out of 5
Related products
-
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
CAT 3126B Fault Code: 70-05 PID: Flash Code 49 SPN: 729 FMI: 5 Inlet Air Heater Open Circuit
3126BRated 0 out of 5 -
CAT 3126B Fault Code: 111-01 PID: Flash Code 62 SPN: 111 FMI: 17 Low Coolant Level Warning
3126BRated 0 out of 5