Cummins ISB CM550 (1990-94) Fault Code: 135 PID: 100 SPN: 100 FMI: 3 Oil Pressure Sensor Circuit
Circuit Description
The oil pressure sensor is used by the electronic control module (ECM) to monitor the lubricating oil
pressure. The ECM monitors the voltage on the signal pin and converts this to a pressure value. The
oil pressure value is used by the ECM for the engine protection system.
Component Location
The oil pressure sensor is located on the engine block, below and to the right of the ECM.
Shop Talk
1) If Fault Code 143 or 415 is not present, the problem is not related to the engine lubrication
system.
2) Your diagnostic tool can be used to monitor the oil pressure signal voltage going into the ECM.
Related products
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
