Cummins ISB CM550 (1990-94) Fault Code: 286 PID: SID 231 SPN: 639 FMI: 13 J1939 Datalink Multiplexing
Circuit Description
Inputs, such as throttle pedals, switches, and sensors, can be communicated to the ECM over the J1939 datalink. Messages sent from the vehicle electronic control units (VECUs) are
received by the ECM and used for controlling the engine. Both the ECM and VECU must be
properly configured so that each device’s information is transmitted by the VECU and received
by the ECM.
Component Location
The ECM is located on the intake side of the engine, about mid-engine. The J1939 datalink
wiring and VECU(s) vary by OEM options.
Shop Talk
This fault occurs when the ECM is set up to receive information from several multiplexed
switches from VECU(s) and only receives some of the switches. It indicates the ECM is set up
to receive too many switches or the VECU(s) is set up to transmit too few switches.
Related products
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00
