Cummins ISB CM550 (1990-94) Fault Code: 352 PID: SID 232 SPN: 620 FMI: 3 Sensor Supply Circuit
Circuit Description
The engine position sensor (EPS), the intake manifold pressure sensor, and the oil pressure sensor are powered by the same +5-VDC source and the same return in the electronic control module (ECM). This supply is also used to operate the intake manifold temperature and coolant temperature
sensors.
Component Location
The +5-VDC sensor supply circuit is located in the sensor harness. Refer to Procedure 100-002 (Engine Diagrams) in Section E for the sensor locations.
Shop Talk
These faults could also cause high-voltage or low-voltage faults on the coolant temperature and intake manifold temperature sensors.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
-
