Cummins ISB CM550 (1990-94) Fault Code: 433 PID: 102 SPN: FMI: 2 Intake Manifold Pressure Sensor Circuit
Circuit Description
The intake manifold pressure sensor monitors intake manifold pressure and passes information to the
electronic control module (ECM) through the engine harness. If intake manifold pressure becomes too
high, it will cause a derate condition.
Component Location
The intake manifold pressure sensor is located in the side of the intake manifold, just to the right of
the fuel filter.
Shop Talk
The ECM checks for this fault only at idle speed. If the intake manifold pressure shows too high of a
value at this time, the ECM will log a fault code.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
