Cummins ISX11.9 CM2250 (2010-12) Fault Code: 1117 PID: SID 251 SPN: 627 FMI: 2 Power Supply Lost With Ignition on- Data Erratic, Intermittent, or Incorrect
The electronic control module (ECM) receives constant voltage from the batteries through the unswitched battery wires that are connected directly to the positive (+) battery post. The ECM receives switched battery input through the vehicle keyswitch wire when the vehicle keyswitch is turned ON.
The ECM is connected to the battery by the OEM power harness through the ECM battery supply stub. This provides a constant power supply for the ECM. The location of the battery will vary with the original equipment manufacturer (OEM). Refer to the OEM service manual.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position.
Conditions for Setting the Fault Codes
The ECM detects that primary ECM power supply dropped below a calibratible value while the keyswitch was in the ON position. The fault code will be active when the keyswitch is turned on following the incomplete power-down event.
Action Taken When the Fault Code is Active
The ECM records the fault code immediately when the diagnostic runs and fails.
Power-down data like trip information, maintenance monitor, and fault information will not get saved to permanent memory when the keyswitch is turned OFF.
Conditions for Clearing the Fault Code
To validate the repair, start the engine, let it idle for 1 minute, and shut it down properly. The ECM must see adequate primary ECM battery voltage when the keyswitch is turned OFF before the fault code will go inactive.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults.
Possible causes of this fault code are:
Battery voltage below 6.2 VDC during cranking
High resistance in the ECM supply or return circuit
Use of a battery disconnect switch or any device that disconnects battery voltage to the ECM to turn the engine off or before the ECM is completely powered down.
Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.
1) Loose Connection/ Terminals
2) Battery Failure
4) OEM power Harness
5) ECM power harness
6) OEM harness
7) ECM calibration
Wabco PIN Code Calculator Diagnostic Software PIN 1 PIN 2Trucks software $10.00
Hino DX3 1.22.10 2022 ( 1 PC )Hino $96.00
Thermo King EPC 2012Thermo King $45.00
CUMMINnSsg INSITEr 220.127.116.11 PRO + ZAP-ITcummisznn $70.00
Perkins EST 2016C Electronic Service ToolPerkins $50.00
SERVICE MANUAL MACK MP7 2007MACK $30.00
SERVICE MANUAL BOBCAT 3200 smsBOBCAT $40.00
MANUAL SERVICE DEUTZ AGROTRON TTV 1130-1145-1160DEUTZ $32.00
SERVICE MANUAL BOBCAT 100 smsBOBCAT $54.00
SERVICE MANUAL BOBCAT 310 – 313 SMSBOBCAT $45.00
MANUAL SERVICE DEUTZ AGROTRON K 90-100-110-120DEUTZ $34.00
SERVICE MANUAL HINO FD.FE.FF.SG 2001HINO $35.00
SERVICE MANUAL International Engines DT466 (2004-2006)INTERNATIONAL ENGINES $45.00
SERVICE MANUAL MACK V-MAC IV 2007 EMISSIONSMACK $27.00