Cummins ISX12 CM2250 (2010-12) Fault Code: 3422 PID: SPN: 4344 FMI: 3 Aftertreatment Diesel Exhaust Fluid Line Heater 3 Circuit- Voltage Above Normal or Shorted to High Source
The aftertreatment diesel exhaust fluid line heater 3 is controlled by the aftertreatment diesel exhaust fluid controller, and receives power through the switch side of the diesel exhaust fluid line heater relay.
The aftertreatment diesel exhaust fluid line heater 3 is located on the suction line between the diesel exhaust fluid tank and diesel exhaust fluid dosing unit.
Conditions for Running the Diagnostics
This diagnostic runs when the keyswitch is in the ON position and the heater is commanded on.
Conditions for Setting the Fault Codes
The aftertreatment diesel exhaust fluid controller detects that the line heater voltage is above a calibratible value.
Action Taken When the Fault Code is Active
The electronic control module (ECM) illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
The line heater will be disabled.
Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
To validate the repair, perform a key cycle, and then use INSITE? electronic service tool to perform the Diesel Exhaust Fluid Doser System Heater Test found under ECM Diagnostic Tests.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after all three line heaters are commanded on and the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.
For On-Board Diagnostic (OBD) engines, the ECM will turn off the MIL after three consecutive trips where the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes of this fault include:
Malfunctioning line heater
Short circuit to battery in the aftertreatment diesel exhaust fluid controller harness
Malfunctioning aftertreatment diesel exhaust fluid contoller.
Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.
For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.
1) Aftertreatment DEF line heater 3 failure
2) Aftertreatment DEF controller failure
3) ECM calibration
Bendix Acom Pro 2022 v3 ( 1 PC ) BENDIX 2022 V3Bendix $85.00
Wabco PIN Code Calculator Diagnostic Software PIN 1 PIN 2Trucks software $10.00
SERVICE MANUAL BOBCAT 5610 SMSBOBCAT $49.00
SERVICE MANUAL BOBCAT 435 SMSBOBCAT $56.00
SERVICE MANUAL BOBCAT 442 smsBOBCAT $50.00
SERVICE MANUAL BOBCAT 773 smsBOBCAT $45.00
SERVICE MANUAL BOBCAT 853 smsBOBCAT $40.00
MANUAL SERVICE DEUTZ AGROTRON TTV 1130-1145-1160DEUTZ $32.00
SERVICE MANUAL Carrie Supra 550 650 750 850 950CARRIE $20.00
SERVICE MANUAL International Engines N9 & N10INTERNATIONAL ENGINES $24.00
SERVICE MANUAL HINO FD.FE.FF.SG 2020HINO $35.00
SERVICE MANUAL BOBCAT 430 SMSBOBCAT $52.00