Cummins ISX12 CM2250 (2010-12) Fault Code: 585 PID: SID 39 SPN: 677 FMI: 4 Starter Relay Driver Circuit- Voltage Below Normal or Shorted to Low Source
The starter lockout relay is controlled by the electronic control module (ECM) through the starter lockout relay signal circuit. The relay prevents the starter from being engaged when the engine is running. The relay return circuit is dependent on OEM wiring. It can be wired back to the ECM on some vehicles or wired to chassis or block ground on others. Consult the OEM wiring diagram for return circuit details. The starter lockout relay circuit utilizes a pulse width modulated (PWM) signal. A PWM signal is a pulsed voltage signal between 0-VDC and system voltage. The frequency of the pulsed voltage signal is dependent on the application requirement.
The starter lockout relay is installed by the vehicle OEM. Refer to the OEM service manual for component location.
Conditions for Running the Diagnostics
This diagnostic runs when the keyswitch is in the ON position and when the PWM device is being energized or de-energized. In some cases the diagnostics can also run at some fixed intervals.
Conditions for Setting the Fault Codes
The starter lockout relay circuit PWM signal is detected to be greater than 0-VDC when the PWM signal is turned off.
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE light immediately when the diagnostic runs and fails.
The starter lockout feature will be disabled.
Conditions for Clearing the Fault Code
To validate the repair, start the engine and let it idle for 1 minute.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE light after the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults.
The ECM monitors the voltage level on this circuit. If it detects a low voltage when the signal is commanded ON, it records this fault code. This fault code can be caused by a short circuit to ground in the starter lockout relay, OEM harness, or connectors.
Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.
For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.
1) Starter lockout relay failure
2) OEM harness
3) ECM failure
VOLVO PROSIS 2023 ( 11.2022 )Trucks software $96.00
Meritor Wabco Tool Box 12.12Trucks software $40.00
Diamond Logic Builder DLB 2018Navistar $40.00
SERVICE MANUAL HINO FD.FE.FF.SG 2011_2013HINO $34.00
SERVICE MANUAL International Engines MaxxForce 15INTERNATIONAL ENGINES $40.00
SERVICE MANUAL International Engines VT275 (2004 & Older)INTERNATIONAL ENGINES $21.00
SERVICE MANUAL VOLVO DD12A (1993-1998)TRUCK MANUALS $38.00
SERVICE MANUAL Carrie 30sCARRIE $20.00
SERVICE MANUAL MACK V-MAC IV (2010 Emissions)MACK $40.00
SERVICE MANUAL Carrie Integra 40 50SCARRIE $20.00
SERVICE MANUAL DETROIT Earings – Technicians GuideDETROIT $18.00
SERVICE MANUAL Carrie Integra 30sCARRIE $20.00
SERVICE MANUAL BOBCAT 773 smsBOBCAT $45.00