Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 3239 PID: SPN: 4342 FMI: 3 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit- Voltage Above Normal or Shorted to High Source
The aftertreatment diesel exhaust fluid line heaters are used to defrost and/or prevent freezing of the diesel exhaust fluid lines.
The aftertreatment diesel exhaust fluid line heater 2 is located on the return line between the diesel exhaust fluid dosing unit and diesel exhaust fluid tank.
Conditions for Running the Diagnostics
This diagnostic runs when the keyswitch is in the ON position and line heating is commanded OFF.
Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected the line heater voltage was above a calibratible value and the line heater current was above a calibratible value.
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
The line heater will be disabled.
Diesel exhaust fluid injection into the aftertreatment system is disabled.
Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
To validate the repair, perform a key cycle, and then use INSITE™ electronic service tool to perform the Diesel Exhaust Fluid Doser System Heater Test found under ECM Diagnostic Tests.
The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes of this fault include:
Malfunctioning line heater
A short circuit to battery in the OEM harness
Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.
For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.
1) Aftertreatment DEF line heater 2 failure
2) Aftertreatment DEF line heater relay failure
3) OEM harness
4) ECM calibration
SERVICE MANUAL International Engines DT466E & DT530E (1999 & Older)INTERNATIONAL ENGINES $31.00
SERVICE MANUAL HINO FD.FE.FF.SG 2001HINO $35.00
SERVICE MANUAL Fuso FE & FG Series 2005-2007FUSO $34.00
SERVICE MANUAL HINO FD.FE.FF.SG 2018HINO $41.00
SERVICE MANUAL BOBCAT 320-322BOBCAT $65.00
SERVICE MANUAL Carrie CT3-69-TVCARRIE $20.00
SERVICE MANUAL Gen 1 – AutoSelect & AutoShiftEATON $25.00
SERVICE MANUAL INTERNATIONAL ENGINE VT365 (2004 & Newer)INTERNATIONAL ENGINES $24.00
SERVICE MANUAL Bendix TU-FLO 550 CompressorBENDIX $17.00