Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 6653 PID: SPN: 7854 FMI: 6 Aftertreatment 1 Diesel Particulate Filter Soot Sensor Module- Current Above Normal or Grounded Circuit
The aftertreatment particulate matter sensor is a smart device and communicates with the engine control module (ECM) via the J1939 data link. The aftertreatment particulate matter sensor performs internal diagnostics and reports malfunctions back to the primary ECM using the J1939 data link. The particulate matter sensor is permanently attached to the particulate matter control module. They are serviced as a single component and can not be replaced individually. The aftertreatment particulate matter sensor is used to measure the soot emissions at the outlet of the aftertreatment system.
The aftertreatment particulate matter sensor location can vary depending on engine application. It is usually located in the exhaust system at the outlet of the selective catalytic reduction (SCR) catalyst.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the engine is running.
Conditions for Setting the Fault Codes
The aftertreatment particulate matter sensor has detected low resistance in its power supply.
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or Malfunction Indicator Lamp (MIL) after the diagnostic fails on two consecutive trips.
Conditions for Clearing the Fault Code
To validate the repair, start the engine and let it idle for 1 minute.
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes for this fault include:
Malfunctioning aftertreatment particulate matter sensor
1) Aftertreatment Particulate sensor failure
2) Loose Connections
3) OEM harness
4) ECM calibration
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2Trucks software $35.00
Wabco ToolBox plus 18.104.22.168 + ECAS CAN2 v3.00 Diagnostics SoftwareTrucks software $84.00
SERVICE MANUAL DETROIT DIESEL DDDL 7 UDETROIT $20.00
SERVICE MANUAL International Engines MaxxForce 7 (2010 & Newer)INTERNATIONAL ENGINES $34.00
SERVICE MANUAL I2017 International® A26 EngineINTERNATIONAL ENGINES $24.00
SERVICE MANUAL EATON CEEMAT TRSM0020EATON $24.00
SERVICE MANUAL HINO FD.FE.FF.SG 2016HINO $40.00
SERVICE MANUAL BOBCAT 953 smsBOBCAT $40.00
SERVICE MANUAL BOBCAT 225 SMSBOBCAT $60.00