Detroit DD13 GHG14 (2014-16) Fault Code: SPN 51 FMI 2 (MCM) Intake Throttle Position Deviation Error
DESCRIPTION:
This code sets when the Intake Throttle Valve Position has a 15% deviation from the position commanded by the Motor Control Module (MCM) when the engine coolant temperature is above 60°C (140°F).
MONITORED PARAMETER:
Intake Throttle Valve (ITV)
TYPICAL ENABLING CONDITIONS:
Coolant temperature is greater than 60°C (140°F).
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
Five seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
10% Derate
VERIFICATION:
Engine rpm = 600 rpm or higher.
POSSIBLE CAUSES:
1. Faulty ITV motor.
2. Faulty ITV position sensor.
3. Sticking ITV.
PROBABLE CAUSES:
1. Air throttle valve harness.
2. ITV harness connector.
3. Intake throttle valve failure.
4. Cold temperatures may falsely cause this code to appear.
5. Intake throttle valve sensor.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00
