Detroit DD15 EPA07 (2007-09) Fault Code: SPN 110 FMI 0 (CPC) Coolant Temperature High

DESCRIPTION:
This code sets once the motor control module (MCM) detects that the outlet coolant temperature is above 112°C (234°F).

MONITORED PARAMETER:
Engine coolant outlet temperature sensor.

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
Two seconds

DASH LAMPS:
1. MIL
2. CEL

VERIFICATION:
Outlet coolant temperature above 112°C (234°F) followed by one minute of idling.

NOTE: If codes 110-3 or 110-4 also active, fix those first.

NOTE: With a code engine, coolant inlet and coolant outlet temperature should be within 25 degree’s of each other. If not, replace both sensors.

Otherwise, most PROBABLE failures are:
1. Low coolant.
2. Thermostat failure.
3. Blockage in radiator and/or charge air cooler.
4. Fan belt failure.
5. Fan shroud failure or installed improperly.
6. Radiator hose failure (collapsed hoses).
7. Engine fan failure.