Detroit DD15 EPA07 (2007-09) Fault Code: SPN 3250 FMI 8 (MCM) Diesel Oxidation Catalyst Outlet Temperature – Signal Spike
NOTE: This fault indicates the Motor Control Module (MCM) has detected an impossible temperature shift on the Diesel Oxidation Catalyst (DOC) outlet temperature sensor. The most likely cause is an intermittent wiring concern.
NOTE: If any other codes are active, fix those first.
PROBABLE CAUSES:
1. Inspect all connectors upstream of the MCM (DOC outlet temperature, ATD harness 10-pin connector, VIH 31-pin connector, and ECM 120-pin connector).
2. DOC outlet temperature sensor.
3. DPF inlet pressure sensor.
4. DPF inlet pressure sensor connector/harness.
5. DPF outlet pressure sensor.
6. DPF outlet pressure sensor connector/harness.
7. DPF is contaminated with oil or coolant.
8. DOC failure.
9. Intake manifold or charge air cooler failure.
10. Intake manifold pressure sensor.
11. Turbocharger failure.
12. Fuel doser injector valve leaks.
13. Failed cylinder injectors.
14. DPF failure.
15. Perform a stationary regen.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
