Eaton Gen 1 (AutoShift) Fault Code: 73 PID: SID 58 FMI: 7 Failed To Engage Gear
Overview:
This code indicates the transmission is unable to engage the desired gear in the front box during a shift.
Detection:
The transmission detects this by attempting the same shifter actions five times and not sensing the desired position.
Fallback:
This causes an In Place fallback.
Required Tools:
1) Basic Hand Tools
2) Digital Volt/Ohm Meter
3) AutoSelect/AutoShift Troubleshooting Guide
Possible Causes:
1) Malfunctioning electric shifter
2) Malfunctioning yoke/clutch/mainshaft
3) Failed shift block
4) Failed or misaligned shift block
5) Electric shifter calibration
6) Failed gear select sensor
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
