Shop
Account
Cart $0.00
0
0
Subtotal: $0.00
No products in the cart.

Eaton Gen 2 (AutoShift) Fault Code: 58 PID: 191 FMI: 2 Output Shaft Speed Sensor

Overview:
Fault Code 58 indicates an electrical problem in the Output Shaft Speed Sensor circuit. The signal from the sensor did not match the current operating conditions.

Detection:
A Speed Sensor is determined faulty when all Speed Sensor readings are compared and one sensor is inconsistent.

Fallback:
This fault causes a 5-speed fallback and the transmission stays in either low range or high range. When the vehicle comes to a stop, an attempt to shift into low range is made. The fallback causes a 1-speed fallback on transmissions with no auxiliary section.

Possible Causes:
1) Transmission Harness
2) Output Shaft Speed Sensor
3) Various transmission components
4) Transmission Controller
5) Failed or loose Tone Wheel

Shop Talk:
Select a forward gear and drive at a steady speed no slower than 10 MPH. It may be necessary to operate the vehicle for a prolonged period of time
if the cause of the failure is related to heat and vibration.

Categories , , Tags , , , , , , , , , , , , ,
Facebook Twitter Youtube
Wiring Diagrams
Component Locators

Related products