PACCAR MX (2004 Emissions) Fault Code: P1566 Idle Speed Control – Incorrect
PACCAR MX (2004 Emissions) Fault Code: P1566 Idle Speed Control – Incorrect
SET CONDITIONS:
The PCI ECU (D420) detects that the actual fuel quantity during idling:
1. Differs on average more than 40 mg/stroke for more than 5 seconds from the requested fuel quantity, four times consecutively or
2. Is above 75 mg/stroke for more than 24 seconds or
3. Is below 8 mg/stroke for more than 24 seconds
DIAGNOSTIC CONDITION:
The diagnostic runs when the engine operating state is Idle.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
POSSIBLE CAUSES:
1. Heavy load on engine during idling
2. fuel system failure
3. External fuel supply source
ADDITIONAL INFORMATION:
The idle speed governor function in the PCI ECU controls the idle speed. This diagnostic monitors that the actual fuel quantity during idling does not deviate too much from the requested fuel quantity during idling.
-
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5
-
Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino $60.00Rated 0 out of 5 -
DETROIT DDDL 8.14 SP3 – Detroit Diesel Diagnostic Link 8.14 SP3 2021 ( 1PC )
Detroit $73.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5
Related products
-
Allison Transmission – WTEC 2 MD/HD/B SERIES TRANSMISSIONS
Allison$20.00Original price was: $20.00.$16.00Current price is: $16.00.Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce DT 9 10 (2007-2009)
INTERNATIONAL ENGINES $30.00Rated 0 out of 5