Volvo All Engines (2010 Emissions) Fault Code: SPN 100 FMI 2 PID: 100 Engine Oil Pressure
The Engine Oil Pressure Sensor is used to detect engine lubrication system failures. The sensor consists of a pressure sensitive diaphragm and amplifier. Engine oil pressure causes the sensor’s diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor. The sensor’s signal is monitored by the Engine Control Module (ECM). The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Sensor value differs from estimated value
Observable symptoms
1) Engine de-rated
Probable cause
1) Engine oil pressure (EOP) sensor
2) Engine wiring harness
Related products
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P20CA00 PID: ACM Reductant Injection Air Pressure Leakage
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P266912 PID: ACM Actuator Supply Voltage “B”
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20B113 PID: ACM Reductant Heater Coolant Control Valve Control
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 110 FMI 17 PID: Engine Coolant Temperature – Least Severe Level
All Engines (2010 Emissions) -
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 1127 FMI 10 PID: Engine Turbocharger 1 Boost Pressure
All Engines (2010 Emissions) -
-
