Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 14 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Abnormal value : Low
Observable symptoms
1) Engine de-rated
2) Black smoke
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor connector
3) Charge air system leakage
Related products
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P25AB00 PID: EMS Piston Cooling Oil Control Circuit High
All Engines (2013 Emissions) -
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P033531 PID: EMS Crankshaft Position Sensor “A”
All Engines (2013 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P04DA00 PID: EMS Closed Loop EGR Control At Limit – Flow Too High
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 633 FMI 4 PID: SID 18 Engine Fuel Actuator 1 Control Command
All Engines (2010 Emissions) -
-
-
-
