Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 2 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
2) Irrational pressure compared to atmospheric pressure and crankcase pressure
Observable symptoms
1) Low Power
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Inlet and exhaust system
Related products
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P10FF86 PID: EMS Reductant Level Sensor “A” Circuit Electrical
All Engines (2017 Emissions) -
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Volvo All Engines (2013 Emissions) Fault Code: P20DD01 PID: EMS Exhaust Aftertreatment Fuel Supply Control
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P066800 PID: ACM PCM/ECM/TCM Internal Temperature Sensor “A”
All Engines (2013 Emissions)
