Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 2 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
2) Irrational pressure compared to atmospheric pressure and crankcase pressure
Observable symptoms
1) Low Power
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Inlet and exhaust system
Related products
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 10 Starter Output
All Engines (2004 Emissions) -
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID158 FMI 4 ECU Battery Potential
D12D AE E3 (Tier 3) -
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 173 FMI 2 PID: Engine Exhaust Gas Temperature
All Engines (2010 Emissions) -
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 8 PID: PSID 7 Calibration memory
All Engines (2010 Emissions) -
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD15 EPA10 (2010-13)
