Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 2 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
2) Irrational pressure compared to atmospheric pressure and crankcase pressure
Observable symptoms
1) Low Power
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
2) Inlet and exhaust system
Related products
-
PACCAR MX (2004 Emissions) Fault Code: P1498 EGR Valve Position – Incorrect
MX (2004 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: U300046 PID: EMS Electronic Control Unit
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20E997 PID: ACM Reductant Pressure Too High
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P110512 PID: EMS Engine Rear Start Switch “A” Circuit
All Engines (2013 Emissions) -
-
