Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 3 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:22 is less than 0.29?V
Observable symptoms
1) Low Power
2) The charge pressure gauge shows 0 in the instrument
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor
Detailed information
1) Pressure set to atmospheric pressure plus 30 kPa (4.5 psi)
Related products
-
-
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 91 FMI 13 (CPC) Data Out of Calibration
DD13 GHG14 (2014-16) -
Volvo All Engines (2004 Emissions) Fault Code: SID 3 FMI 7 Fuel Injector Unit #3
All Engines (2004 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P208A00 PID: ACM Reductant Pump “A” Control
All Engines (2013 Emissions) -
-
-
-
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P117B11 PID: EMS Engine Compartment Temperature Sensor Switch
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P204264 PID: ACM Reductant Temperature Sensor
All Engines (2017 Emissions) -
