Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 5 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:22 is less than 0.29?V
Observable symptoms
1) Low Power
2) The charge pressure gauge shows 0 in the instrument
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor
Detailed information
1) Pressure set to atmospheric pressure plus 30 kPa (4.5 psi)
Related products
-
-
-
-
-
PACCAR MX (2004 Emissions) Fault Code: P1601 PCI ECU – Internal Error
MX (2004 Emissions) -
PACCAR MX (2004 Emissions) Fault Code: P1489 EGR Valve – Stuck Closed
MX (2004 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20BD13 PID: ACM Reductant Heater “B” Control
All Engines (2013 Emissions) -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3245 FMI 1 PID: PPID 436 Aftertreatment DPF Outlet Temperature
All Engines (2010 Emissions) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P208A11 PID: ACM Reductant Pump “A” Control
All Engines (2017 Emissions) -
