Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 8 PID: Engine Intake Manifold
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) Charge pressure Low
Probable cause
1) Wiring harness
2) Intake manifold air temperature (IMAT) and pressure sensor
Related products
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 24 PID: SPN: 100 FMI: 3 Oil Pressure voltage high
3406E (Prefix 1MM or 2WS) -
Volvo All Engines (2017 Emissions) Fault Code: P114101 PID: EMS Buffered Idle Validation Switch Wire – ECM Side
All Engines (2017 Emissions)
