Volvo All Engines (2010 Emissions) Fault Code: SPN 103 FMI 2 PID: Engine Turbocharger
The Turbo Speed Sensor is an inductive sensor. When the engine is running, the turbocharger shaft rotates past the Turbo Speed Sensor tip and a pulsed voltage signal is generated. The Engine Control Module (ECM) monitors the frequency of the signal generated by the Turbo Speed Sensor to calculate the turbo speed.
The turbo speed signal is used to calculate fuel injection.
Conditions for diagnostic trouble code (DTC):
1) A charge air pressure sensor that is indicating a higher than normal value in some cases can set a turbocharger speed sensor fault
Probable cause
1) Turbo Speed Sensor
2) Incorrectly installed sensor
3) Faulty parameters
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
Related products
-
-
-
-
-
-
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 168 FMI 18 (CPC) Battery Voltage Low
DD13 GHG14 (2014-16) -
Volvo All Engines (2017 Emissions) Fault Code: P027300 PID: EMS Cylinder 5 Injector Circuit Low
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P020512 PID: EMS Cylinder 5 Injector “A”
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P065712 PID: ACM Actuator Supply Voltage “A”
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P026C00 PID: EMS Fuel Injection Quantity Lower Than Expected
All Engines (2013 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P06B016 PID: EMS Sensor Power Supply “A”
All Engines (2013 Emissions)
