Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 17 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake manifold air temperature (IMAT) and pressure sensor
Related products
-
-
-
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3556 FMI 5 PID: PPID 329 Aftertreatment Doser
All Engines (2010 Emissions) -
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 986 FMI 9 (CPC) CM1 Message is Missing
DD15 EPA10 (2010-13) -
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 41 PID: SPN: 84 FMI: 0 Vehicle Overspeed Warning
3406E (Prefix 1MM or 2WS) -
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 73 PID: 3 SPN: FMI: 11 Cylinder #3 Injector current fault
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 629 FMI 8 PID: SID 254 Electronic Control Unit (ECU) 1
All Engines (2010 Emissions) -
