Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 2 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake Manifold Pressure/Temperature Sensor
2) Wiring harness
![Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]](https://www.ecuforcetruck.com/wp-content/uploads/2021/10/1-300x300.png)
Related products
-
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output
All Engines (2004 Emissions) -
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 94 FMI 3 Fuel Pressure (FP) Sensor
All Engines (2004 Emissions) -
-
-
-
-
-
-
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 62 PID: SPN: 111 FMI: 1 Low Coolant Level Warning
3406E (Prefix 1MM or 2WS) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P009B11 PID: EMS Fuel Pressure Relief Control
All Engines (2013 Emissions) -
