Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 2 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake Manifold Pressure/Temperature Sensor
2) Wiring harness
Related products
-
-
-
-
-
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 51 PID: 168 SPN: FMI: 2 ECM Battery Power Intermittent
3406E (Prefix 5DS or 1LW) -
-
-
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 647 FMI 5 (MCM) Fan Open Circuit
DD16 EPA07 (2007-09) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 3216 FMI 14 PID: PPID 348 Aftertreatment Intake NOx
All Engines (2010 Emissions) -
-
Volvo All Engines (2013 Emissions) Fault Code: P011200 PID: EMS Intake Air Temperature Sensor 1 Circuit Low Bank 1
All Engines (2013 Emissions) -
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD13 EPA07 (2007-09) -
-
-
