Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 2 PID: Engine Intake Manifold 1 Temperature
The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system after the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier sensor. Air pressure causes the sensors diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor.
The sensor signals are used to calculation fuel injection and is monitored by the Engine Control Module (ECM).
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
Probable cause
1) Intake Manifold Pressure/Temperature Sensor
2) Wiring harness
Related products
-
-
Volvo All Engines (2017 Emissions) Fault Code: P03351F PID: EMS Crankshaft Position Sensor “A”
All Engines (2017 Emissions) -
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 2836 FMI 4 PID: PSID 49 Battery 1 Potential 2 (Voltage), Switched
All Engines (2010 Emissions) -
-
-
-
-
-
-
Allison 3000 & 4000 Gen 4 Fault Code: P0613 TCM Processor
3000 & 4000 Gen 4 -
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 251 FMI 12 PID: Time
All Engines (2010 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P203D00 PID: ACM Aftertreatment Reagent Level Short Circit High
All Engines (2017 Emissions) -
