Volvo All Engines (2010 Emissions) Fault Code: SPN 1127 FMI 10 PID: Engine Turbocharger 1 Boost Pressure
The engine control module (ECM) monitors the intake manifold pressure (IMP) sensor and controls the boost air system (mainly controlled by the VGT) and the engine turbocharger compressor bypass valve. The ECM also uses parameters like engine speed (RPM) and turbocharger speed to make a calculation of the IMP. This estimated value should not differ too much from the measured value.
Conditions for diagnostic trouble code (DTC):
1) Poor intake manifold pressure (IMP) response
Observable symptoms
1) Power loss
2) Poor response
Probable cause
1) Charge air system leakage
Related products
-
-
Volvo All Engines (2013 Emissions) Fault Code: P203764 PID: ACM Reductant Injection Air Pressure Sensor “A”
All Engines (2013 Emissions) -
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 168 FMI 1 (MCM) Battery Voltage Low
DD15 GHG14 (2014-16) -
Volvo All Engines (2013 Emissions) Fault Code: P20B300 PID: EMS Reductant Heater Coolant Control Valve Circuit Low
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P108013 PID: ACM Actuator Supply Voltage “D”
All Engines (2013 Emissions) -
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P019064 PID: EMS Fuel Rail Pressure Sensor Bank 1
All Engines (2013 Emissions) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PID: SPN: 231 FMI: 12 J1939 Device Not Responding
3406E (Prefix 1MM or 2WS) -
