Volvo All Engines (2010 Emissions) Fault Code: SPN 1265 FMI 3 PID: SID 85 Engine Piston Cooling Oil Pressure Actuator
The engine piston cooling oil supply valve is located in the oil filter housing and is used to control the piston cooling oil pressure. The engine control module (ECM) controls the valve by monitoring the signal from the piston cooling oil pressure sensor. If an electrical fault is detected inside the valve it will be fully open (fail safe).
Conditions for diagnostic trouble code (DTC):
1) Output activated
2) The current at pin A14.EB:41 is above 2.2?A
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Low oil pressure at low engine speed
Probable cause
1) Short circuit to voltage supply, control wire
2) Short circuit in control valve
Related products
-
Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3719 FMI 16 (ACM) Soot Level High
DD15 EPA10 (2010-13) -
Volvo All Engines (2017 Emissions) Fault Code: P204A11 PID: ACM Reductant Pressure Sensor
All Engines (2017 Emissions) -
PACCAR MX (2004 Emissions) Fault Code: P1602 PCI ECU – Software Error
MX (2004 Emissions) -
-
-
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed
DD15 GHG14 (2014-16) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P111900 PID: EMS Intake Manifold Temperature Moderately Too High
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P112E00 PID: EMS Exhaust Gas Temperature Moderately High Bank 1
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P02E013 PID: EMS Diesel Intake Air Flow Control
All Engines (2017 Emissions)
