Volvo All Engines (2010 Emissions) Fault Code: SPN 1265 FMI 3 PID: SID 85 Engine Piston Cooling Oil Pressure Actuator
The engine piston cooling oil supply valve is located in the oil filter housing and is used to control the piston cooling oil pressure. The engine control module (ECM) controls the valve by monitoring the signal from the piston cooling oil pressure sensor. If an electrical fault is detected inside the valve it will be fully open (fail safe).
Conditions for diagnostic trouble code (DTC):
1) Output activated
2) The current at pin A14.EB:41 is above 2.2?A
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Low oil pressure at low engine speed
Probable cause
1) Short circuit to voltage supply, control wire
2) Short circuit in control valve
Related products
-
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD13 GHG14 (2014-16) -
-
-
-
-
-
-
-
-
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 13 PID: 174 SPN: FMI: 3 Fuel Temperature voltage high
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 633 FMI 5 PID: SID 18 Engine Fuel Actuator 1 Control Command
All Engines (2010 Emissions) -
-
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 172 FMI 4 Intake Air and Humidity Sensor
All Engines (2004 Emissions)
