Volvo All Engines (2010 Emissions) Fault Code: SPN 1265 FMI 5 PID: SID 85 Engine Piston Cooling Oil Pressure Actuator
The engine piston cooling oil supply valve is located in the oil filter housing and is used to control the piston cooling oil pressure. The engine control module (ECM) controls the valve by monitoring the signal from the piston cooling oil pressure sensor. If an electrical fault is detected inside the valve it will be fully open (fail safe).
Conditions for diagnostic trouble code (DTC):
1) Output not activated
2) The voltage at pin A14.EB:41 is between 33?% and 67?% of the battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Low oil pressure at low engine speed
Probable cause
1) Open circuit on common supply wire or open circuit on fuse FE9
2) Control wire in engine wiring harness
3) Piston Cooling Valve
![DAF Davie Runtime v5.6.1 Davie XDc ll [02.2019] + Expire Fix 302.00 Unlock ( Windows 7 )](https://www.ecuforcetruck.com/wp-content/uploads/2021/09/Capture-2-300x300.png)
Related products
-
-
PACCAR MX (2004 Emissions) Fault Code: P1675 PCI ECU – Software Error
MX (2004 Emissions) -
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 626 FMI 3 PID: 45 Intake Air Heater (IAH) Relay
All Engines (2010 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P204400 PID: ACM Reductant Temperature Sensor Circuit Low
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2017 Emissions) Fault Code: P110573 PID: EMS Engine Rear Start Switch “A” Circuit
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P065711 PID: ACM Actuator Supply Voltage “A”
All Engines (2013 Emissions) -
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD16 EPA10 (2010-13) -
-
-
-
