Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 7 PID: SID 39 Engine Starter Mode
The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.
Conditions for diagnostic trouble code (DTC):
1) Transmission is not in neutral position
2) Gear selector not in neutral
3) Only for automatic transmission
Observable symptoms
1) Not possible to activate the starter motor
Probable cause
1) Transmission
2) Gear selector
Detailed information
1) Put the gear selector in neutral position and try to start again
2) When the vehicle is equipped with manual transmission the parameter code BZN in ECM should be set to 0
Related products
-
-
-
-
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P021800 PID: EMS Transmission Fluid Over Temperature Condition
All Engines (2013 Emissions) -
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 105 FMI 0 PID: Engine Intake Manifold 1 Temperature
All Engines (2010 Emissions) -
-
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 25 PID: 102 SPN: FMI: 3 Boost Pressure voltage high
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2017 Emissions) Fault Code: P011511 PID: EMS Engine Collant Temperature Sensor 1
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20E892 PID: EMS Reductant Pressure Too Low
All Engines (2013 Emissions) -
