The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.
Conditions for diagnostic trouble code (DTC):
1) Transmission is not in neutral position
2) Gear selector not in neutral
3) Only for automatic transmission
Observable symptoms
1) Not possible to activate the starter motor
Probable cause
1) Transmission
2) Gear selector
Detailed information
1) Put the gear selector in neutral position and try to start again
2) When the vehicle is equipped with manual transmission the parameter code BZN in ECM should be set to 0
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00
Related products
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 132 FMI 1 (MCM) Air Mass Flow Too Low
DD16 EPA10 (2010-13) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 8 PID: PSID 124 Calibration memory
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P204A11 PID: ACM Reductant Pressure Sensor
All Engines (2013 Emissions) -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
DD15 GHG14 (2014-16) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 631 FMI 4 PID: PSID 124 Calibration memory
All Engines (2010 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P114500 PID: EMS Reductant Level Moderately Low
All Engines (2017 Emissions) -
Volvo All Engines (2004 Emissions) Fault Code: PID 412 FMI 3 EGR Temperature After Cooler
All Engines (2004 Emissions)