Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 7 PID: SID 39 Engine Starter Mode
The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.
Conditions for diagnostic trouble code (DTC):
1) Transmission is not in neutral position
2) Gear selector not in neutral
3) Only for automatic transmission
Observable symptoms
1) Not possible to activate the starter motor
Probable cause
1) Transmission
2) Gear selector
Detailed information
1) Put the gear selector in neutral position and try to start again
2) When the vehicle is equipped with manual transmission the parameter code BZN in ECM should be set to 0
Related products
-
-
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3245 FMI 5 PID: PPID 436 Aftertreatment DPF Outlet Temperature
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P047300 PID: EMS Engine Exhuast Back Pressure Circuit High
All Engines (2013 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P012011 PID: EMS Throttle/Pedal Position Sensor “A”
All Engines (2017 Emissions) -
-
Volvo All Engines (2017 Emissions) Fault Code: P222800 PID: EMS Barometric Pressure Circuit Low
All Engines (2017 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P20FE00 PID: ACM Aftertreatment Reagent Pump Control Build Up Failure
All Engines (2017 Emissions) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P10F824 PID: EMS Air Filter Clogged
All Engines (2017 Emissions)
