The Engine Oil Level/Temperature Sensor contains two thermistors, one for engine oil temperature and one for engine oil level. The resistance of the engine oil temperature portion of the sensor changes inversely to the temperature of the engine oil. When the engine oil is cold, the sensor resistance is high. As the temperature of the engine oil increases, the sensor resistance decreases.
The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn the driver and derate the engine to avoid engine damage if the signal is not within programmed limits.
Conditions for diagnostic trouble code (DTC):
1) Temperature too high
Observable symptoms
1) Info lamp lights up if the temperature is moderately above range
2) Red lamp lights up if the temperature is critically above range
3) A buzzer sounds if the temperature is critically above range
4) Engine de-rated
Probable cause
1) Extreme driving conditions
2) Engine cooling fan
3) Oil thermostat
4) Cooling System
5) Clogged oil cooler
6) Engine oil level (EOL) and temperature sensor
Related products
-
Volvo All Engines (2013 Emissions) Fault Code: P21CA00 PID: EMS Reductant Control Module Supply Voltage
All Engines (2013 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P020213 PID: EMS Cylinder 2 Injector “A”
All Engines (2013 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 5394 FMI 5 PID: PSID 89 Aftertreatment DEF Dosing Valve
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P05407F PID: EMS Intake Air Heater “A” Control
All Engines (2013 Emissions) -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 100 FMI 1 (MCM) Low Engine Oil Pressure
DD13 EPA10 (2010-13) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 51 PID: 168 SPN: FMI: 2 ECM Battery Power Intermittent
3406E (Prefix 5DS or 1LW)