The Engine Oil Level/Temperature Sensor contains two thermistors, one for engine oil temperature and one for engine oil level. The resistance of the engine oil temperature portion of the sensor changes inversely to the temperature of the engine oil. When the engine oil is cold, the sensor resistance is high. As the temperature of the engine oil increases, the sensor resistance decreases.
The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn the driver and derate the engine to avoid engine damage if the signal is not within programmed limits.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:31 is below normal value
Observable symptoms
1) The engine oil temperature (EOT) is continously shown as 0 when the engine is running
Probable cause
1) Engine oil level (EOL) and temperature sensor
2) Short circuit to ground, Signal wire
3) Connector
-
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5
Related products
-
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 84 FMI 2 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #1 is Erratic
DD13 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 171 FMI 14 (CPC) J1587 Ambient Air Temperature Sensor Data Not Received this Ignition Cycle
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 524 FMI 9 (CPC) J1939 ETC2 Message Missing
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Volvo Engine D12D AE E3 (Tier 3) Fault Code: SID4 FMI 3 Injector #4
D12D AE E3 (Tier 3)Rated 0 out of 5 -
Allison WTEC II Fault Code: 41 PID: SPN: 25 FMI: Open or short-to-ground, K solenoid circuit
AllisonRated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 520267 FMI 2 (MCM) Motor Control Module Engine Hours Data Erratic, Intermittent or Incorrect
DD13 GHG14 (2014-16)Rated 0 out of 5 -
PACCAR MX (2004 Emissions) Fault Code: P1026 BPV Actuator – Out of Calibration
MX (2004 Emissions)Rated 0 out of 5