The Engine Oil Level/Temperature Sensor contains two thermistors, one for engine oil temperature and one for engine oil level. The resistance of the engine oil temperature portion of the sensor changes inversely to the temperature of the engine oil. When the engine oil is cold, the sensor resistance is high. As the temperature of the engine oil increases, the sensor resistance decreases.
The Engine Control Module (ECM) monitors the voltage drop across the sensor and uses this signal to warn the driver and derate the engine to avoid engine damage if the signal is not within programmed limits.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:31 is below normal value
Observable symptoms
1) The engine oil temperature (EOT) is continously shown as 0 when the engine is running
Probable cause
1) Engine oil level (EOL) and temperature sensor
2) Short circuit to ground, Signal wire
3) Connector
-
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5 -
download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )
MAN $75.00Rated 0 out of 5
Related products
-
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 3471 FMI 3 (MCM) Hydrocarbon Electronic Dosing Valve Circuit Failed High
DD15 EPA07 (2007-09)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 84 FMI 14 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #3 is Missing
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0606 Controller Internal Performance – Not Enabled for Pickups or Med Duty “04”
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Volvo All Engines (2010 Emissions) Fault Code: SPN 102 FMI 15 PID: Engine Intake Manifold
All Engines (2010 Emissions)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3509 FMI 3 (ACM) The 5V Sensor Supply Bank 1 Circuit Failed High
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 625 FMI 8 (CPC) MCM PT-CAN DM1 Message Not Received or has Stopped Arriving
DD13 GHG14 (2014-16)Rated 0 out of 5 -
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 110 FMI 9 (ACM) Coolant Temperature Signal Not Available via Controller Area Network (CAN)
DD16 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3471 FMI 3 (MCM) Hydrocarbon Electronic Dosing Valve Circuit Failed High
DD13 EPA10 (2010-13)Rated 0 out of 5 -
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 5358 FMI 16 (MCM) Cylinder #1 Engine Smoothness Control/Quantity Low
DD15 GHG14 (2014-16)Rated 0 out of 5