Volvo All Engines (2010 Emissions) Fault Code: SPN 2659 FMI 18 PID: PPID 35 Engine Exhaust Gas Recirculation (EGR) Mass Flow Rate – Modertaely Severe level
This function is used to calculate the EGR Mass Flow. The Engine Control Module (ECM) monitors the EGR diffpressure sensor and the EGR temperature sensor after cooler and uses these signals to calculate the EGR Mass Flow data.
Conditions for diagnostic trouble code (DTC):
1) EGR mass flow is below calculated value
2) The EGR mass flow is an calculated value based on a number of sensor signals and software calculations
Probable cause
1) Exhaust leakage
2) Connector
3) Wiring harness
4) EGR Valve
5) EGR differential pressure sensor
6) EGR Cooler
7) EGR System
Detailed information
1) The diagnostic trouble code (DTC) is first set after 30?min when driving with varying engine loads
2) At idle the diagnostic trouble code (DTC) is normally not set to active
3) The diagnostic trouble code (DTC) will be shown as inactive when the ignition key is turned to the 0 position
4) To fully verify the repair it may be necessary to activate vehicle functions or perform a test drive
Related products
-
Detroit DD15 GHG14 (2014-16) Fault Code: SPN 168 FMI 1 (MCM) Battery Voltage Low
DD15 GHG14 (2014-16) -
Volvo All Engines (2017 Emissions) Fault Code: P110E00 PID: EMS Engine Stop Switch Circuit Low
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: U030100 PID: EMS Program Memory Test Cell Mode
All Engines (2013 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 175 FMI 17 PID: Engine Oil Temperature – Least Severe Level
All Engines (2010 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 0 PID: SID 39 Engine Starter Mode
All Engines (2010 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P20DD12 PID: EMS Exhaust Aftertreatment Fuel Pressure Sensor
All Engines (2013 Emissions)