The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is more than 4.75?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Ground wire
3) Short circuit to 5V, Signal wire
4) Short circuit to battery voltage, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5
-
Volvo Engine D12D AE E3 (Tier 3) Fault Code: PID153 FMI 0 Crankcase Pressure
D12D AE E3 (Tier 3) -
Volvo All Engines (2013 Emissions) Fault Code: P229E12 PID: EMS NOx Sensor Bank 1 Sensor 2
All Engines (2013 Emissions) -
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 132 FMI 1 (MCM) Air Mass Flow Too Low
DD13 EPA10 (2010-13) -
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 628 FMI 14 (CPC) XFLASH Failure
DD13 GHG14 (2014-16)