“John Deere Service Advisor 5.4.44 2025 (AG & CF) | Nexiq USB Link 3 Compatible” has been added to your cart. View cart
The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is less than 0.27?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Signal wire
3) Open circuit, Supply wire
4) Short circuit to ground, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5
-
Volvo All Engines (2017 Emissions) Fault Code: P114411 PID: EMS Starter Relay Highside
All Engines (2017 Emissions) -
CAT 3406E (Prefix 1MM or 2WS) Fault Code: 58 PID: SPN: 231 FMI: 12 J1939 Device Not Responding
3406E (Prefix 1MM or 2WS) -
Detroit DD15 EPA07 (2007-09) Fault Code: SPN 91 FMI 4 (CPC) Circuit Failed Low
DD15 EPA07 (2007-09) -
Volvo All Engines (2013 Emissions) Fault Code: P115100 PID: EMS Aftertreatment System Over Temperature
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P269712 PID: EMS Exhaust Aftertreatment Fuel Injector “A”
All Engines (2017 Emissions) -
Volvo All Engines (2010 Emissions) Fault Code: SPN 5485 FMI 11 PID: PSID 121 Aftertreatment 1 DEF Pump Orifice Flow
All Engines (2010 Emissions)