The function identifies and indicates malfunction of the aftertreatment diesel particulate filter (DPF) by analyzing the pressure drop over the aftertreatment DPF. This is done by making a check for deviation between sensor value and a model pressure drop. In some extreme cases the engine will derate.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A137:26 is less than 0.27?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Signal wire
3) Open circuit, Supply wire
4) Short circuit to ground, Signal wire
5) Wiring harness
6) Aftertreatment DPF Differential Pressure Sensor
7) Aftertreatment Control Module (ACM)
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5
-
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 24 PID: 100 SPN: FMI: 3 Oil Pressure voltage high
3406E (Prefix 5DS or 1LW) -
Volvo All Engines (2013 Emissions) Fault Code: P220A1C PID: EMS NOx Sensor Supply Voltage Circuit (Bank 1 Sensor 1)
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P20D900 PID: EMS Exhaust Aftertreatment Fuel Supply Control
All Engines (2017 Emissions)