Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 2 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The sensor signal is not rational
2) Aftertreatment fuel pressure below Placeholder, aftertreatment fuel shutoff valve open
Observable symptoms
1) Regeneration not possible
2) Regeneration aborted
Probable cause
1) Air in the fuel system
2) Aftertreatment fuel shut-off valve, Stuck in one position
3) Fuel filter
4) De-aeration valve
5) Overflow valve
6) Fuel pump
Detailed information
1) This DTC will only set during an aftertreatment DPF service regeneration
Related products
-
-
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P20B992 PID: ACM Reductant Heater “A” Control
All Engines (2017 Emissions) -
-
Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output
All Engines (2004 Emissions) -
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 18 FMI 5 Water in Fuel Valve
All Engines (2004 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P20C100 PID: ACM Reductant Heater “C” Control
All Engines (2017 Emissions) -
-
-
-
-
-
-
