Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 5 PID: PPID 437 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is less than 0.2?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Supply wire
3) Open circuit, Signal wire
4) Short circuit to ground, Signal wire
5) Aftertreatment Fuel Pressure Sensor
6) Engine control module (ECM)
Related products
-
-
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A
1000 & 2000 Gen 5 -
Allison 1000 & 2000 Gen 5 Fault Code:P2764 TCC PCS Control Circuit Low
1000 & 2000 Gen 5 -
-
-
-
-
Volvo All Engines (2010 Emissions) Fault Code: SPN 3250 FMI 3 PID: DPF Spark Assisted Flame Temperature Sensor
All Engines (2010 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P047F00 PID: EMS Exhaust Pressure Control Valve “A” Stuck Open
All Engines (2013 Emissions) -
-
-
-
Detroit DD16 EPA10 (2010-13) Fault Code: SPN 2791 FMI 3 (MCM) Circuit Failed High
DD16 EPA10 (2010-13) -
-
-
-
Volvo All Engines (2017 Emissions) Fault Code: P204400 PID: ACM Reductant Temperature Sensor Circuit Low
All Engines (2017 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P113B01 PID: EMS Turbo Compound Buffer Air Pressure Sensor
All Engines (2013 Emissions)
