Volvo All Engines (2010 Emissions) Fault Code: SPN 3480 FMI 5 PID: PSID 108 Aftertreatment DPF Fuel Pressure
During DPF regeneration the Aftertreatment Fuel Pressure Sensor monitors the fuel pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. During Air Purge the Aftertreatment Fuel Pressure Sensor monitors the air pressure rise and drop in the Aftertreament Hydrocarbon Dosing Module. The Engine Control Module (ECM) uses this input to determine if the system is operating correctly.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:50 is less than 0.2?V
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Regeneration not possible
Probable cause
1) Connector
2) Open circuit, Supply wire
3) Open circuit, Signal wire
4) Short circuit to ground, Signal wire
5) Aftertreatment Fuel Pressure Sensor
6) Engine control module (ECM)
Related products
-
Allison 1000 & 2000 Gen 5 Fault Code:P2761 TCC PCS Control Circuit Open
1000 & 2000 Gen 5 -
-
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High
1000 & 2000 Gen 5 -
-
-
Volvo All Engines (2004 Emissions) Fault Code: PID 224 FMI 2 Immobilizer
All Engines (2004 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P220013 PID: EMS NOx Sensor Bank 1 Sensor 1
All Engines (2017 Emissions) -
Volvo All Engines (2013 Emissions) Fault Code: P20E797 PID: ACM Reductant Injection Air Pressure Too High
All Engines (2013 Emissions) -
-
-
Volvo All Engines (2013 Emissions) Fault Code: P20DC00 PID: EMS Exhaust Aftertreatment Fuel Supply Control
All Engines (2013 Emissions) -
Volvo All Engines (2017 Emissions) Fault Code: P113F11 PID: EMS Buffered Idle Validation Switch Wire – VECU Side
All Engines (2017 Emissions) -
-
-
Allison 3000 & 4000 Gen 4 Fault Code: P0731 Incorrect 1st Gear Ratio
3000 & 4000 Gen 4 -
-
-
-
-
-
-
Volvo All Engines (2004 Emissions) Fault Code: SID 5 FMI 5 Fuel Injector Unit #5
All Engines (2004 Emissions) -
