“CAT ET 2026 Diagnostic Software” has been added to your cart. View cart
The oil thermostat is located in the oil filter housing and controls the engine oil temperature by controlling if the oil is sent through the oil cooler or not. The Engine Control Module (ECM) monitors that the thermostat is working as expected by comparing the Engine Oil Pressure (EOP) Sensor value to a calculated oil temperature.
Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:53 is between 33?% and 67?% of the battery voltage
Diagnostic operating conditions
1) Ignition key in ON position
Observable symptoms
1) Increased fuel consumption
2) Low oil temperature
Probable cause
1) Open circuit on common supply wire or open circuit on fuse FE9
2) Open circuit in the valve
3) Open circuit in component
Related products
-
Detroit DD16 EPA07 (2007-09) Fault Code: SPN 132 FMI 1 (MCM) Air Mass Flow Too Low
DD16 EPA07 (2007-09) -
CAT 3406E (Prefix 5DS or 1LW) Fault Code: 69 PID: 26 SPN: FMI: 5 Auxiliary Output #01 current low
3406E (Prefix 5DS or 1LW)